The guide Choosing well
Clippers or a head shaver? Decide what you want to feel under your hand
“Take it down to zero” might mean the short bristle of a buzz cut or the almost smooth scalp you feel the day after a shave. Two fingers above your ear can tell the difference.
Published Updated
Run them over a patch where you like the length. For an even layer of hair under your palm, clippers with a guard give you a setting you can repeat. For a close finish on short regrowth, that’s the head shaver’s job. The drawing puts the two finishes on the same man. Look at the edge of the temple.

Choose what you want to leave
Left: keep a chosen length with a suitable clipper.
Right: reduce the remaining length with a shaver designed for the scalp.
Illustration of two intended finishes. A shadow may remain visible. The tools shown are generic; check the permitted uses and cutting lengths of the exact model.
What does “no guard” actually leave?
The minimum cutting length depends on the model. A guard number or a word like “zero” won’t guarantee the same finish on another machine. At the barber’s, ask for the setting in millimetres and have a look before going shorter. At home, start one guard longer if you’re unsure. The next setting down will still be there in five minutes.
Back from two weeks away?
Taking longer hair all the way down to a close shave can be a two-tool job. For its particular shaver, the GroomSkull® guide calls for longer hair to be clipped to 2 or 3 mm first. Wahl also points out that its head shaver isn’t designed for long hair. Look up the right starting length in your own device manual.
After that first trim, go and look in daylight. Wanted a shadow, and there it is? Put the shaver away. Wanted a closer finish? Move on to the second tool once the hair is short enough, easing off if a patch begins to sting. Some mornings the best buy has been in the drawer all along.